Engine Power Kit!

Engine Power Kit!


£0.00
£2,966.40
Earn0
reward points


Product details

EXPORT PRICE (No VAT charge): 2472 :00GBP


The 2GR-FE V6 motor is supplied to Lotus with Ultra Thin-Wall Ceramic catalysers (UTC's) fitted in the exhaust log-manifolds. Lotus have to use the engine as it comes from Toyota so they're stuck with these fragile ceramic parts inches from the cylinder head exhaust ports. Any Ferrari 430 owner will tell you of the dangers inherent in that scenario. I have many reports of the failure of the rear catalyser on Lotus V6 installs (less cooling to that side of the engine).

Supercharged motors, with their increased exhaust-gas pressures can wreck ceramic catalysers and I wonder how long these UTC "pre-cats" will tolerate the stresses placed on them - particularly during track-use. I'm pretty certain Lotus are well aware of these issues as the power output of a 3.5Ltr supercharged V6 should be a lot more than 345bhp (flywheel)!

If you're out of warranty and you're looking to INCREASE POWER AND TORQUE, as well as removing those fragile "pre-cats" you need this "Engine Power Kit"! 

It replaces the factory log-manifolds with the unique, stepped 2bular 3-1 design and bigger-bore 57mm diameter downpipes plus the 130mm diameter 200cell HJS HD EURO 6 SPEC Catalyser. THIS IS A COMBINATION DESIGNED FOR MOST POWER AND TORQUE - ONLY 2BULAR BUILD IT. The exhaust sound with these parts fitted is just incredible - an amazing scream which internet videos don't quite capture.

The images show the 70mm 2bular EPK with its high-quality V-band connector between the catalyser and the 2bular system. 

BUT - I CAN BUILD THE EXIT PIPE ON THE CATALYSER TO FIT TO THE 2.5" (63.5mm) FACTORY EXHAUST SYSTEM OR ANY AFTER-MARKET SYSTEM YOU MAY HAVE FITTED ALREADY. Some owners have fitted the 3" (76mm) system from the 380/4** series cars - no problem fitting to that slip-on.

THE KIT IS FULLY SEALED - LIKE THE FACTORY PIPEWORK - WITH 2-BOLT FLANGES AND GASKETS. 

I HAVE SEEN SLIP-JOINS WITH HOSE CLAMPS(!) - OR SPRINGS. THESE CONNECTORS ARE NOT GAS-TIGHT AND LEAKS CAN DAMAGE YOUR CATALYSER OR GENERATE CEL's. NOT GOOD.

ALL GASKETS/FITTING KITS AND WIRING EXTENSIONS FOR THE RE-LOCATED LAMBDA SENSORS ARE INCLUDED.

Lead Time:  2 weeks